1. Vacuum Control - Set number to desired vacuum time. 0
to10
2. Gas Flush Control - Set number to desired gas amount.
Set to “0” if no gas flush is needed.

3. Sealing Control - Set number for desired seal time. Do
not exceed “3” on first test.

4. Power Indicating Light
5. Cooling Control - This is a dwell or delay before the vent
function. Minimum setting is “3”

6. Emergency Stop (When you press this button, the cycle
will be terminated and will advance to the vent function.)
PA-01 Control Panel User Instructions
The desired number set on the panel is a time based setting. Each function
should be tested for proper results. Note - the numbers do not equate to
seconds. The numbers are a “0 – 10” reference.

Sealers Unlimited‘Since 1979’
                 Hand Impulse Sealers-Foot Sealers-Vacuum Sealers                                                 
Ph (760) 522-8389   Fax (760)-477-6238
Chamber vacuum sealers, vacuum sealer bags
Vacuum Bags
Econovac-420 NOW COME
PANEL
New easier to use than LDC
Display Type.